Home / Products / Cold plastic

Cold plastic

from 170 KZT
DOWNLOAD DOCUMENTS SUBMIT A REQUEST
ГОСТ 32830-2014

COLD PLASTIC FOR ROAD MARKING

High-strength two-component coating based on acrylic resin for road marking application without using heating kettles. It cures through a chemical reaction after the hardener is added.

ENGINEERED FOR EXTREME LOADS

Specially developed for areas with heavy abrasion loads: pedestrian crossings, stop lines, parking lots, tunnels, and petrol stations. Minimal shrinkage, with a non-volatile matter content of 98%, preserves sharp profile definition.

APPLICATION METHODS AND PURPOSE

For manual application

Applied using spatulas, manual applicators, and stencils. Suitable for local areas, pedestrian crossings, parking lots, and stop lines.

For machine application

Modified for use with specialized road marking machines and structural marking applicators for solid, structural, and profile lines.

For spray application

Mechanized thin-layer application via spray nozzles.

AVAILABLE FORMULATIONS

By glass bead content:

  • Premix (with intermix glass beads): Beads are distributed throughout the material to provide retroreflection as the marking wears.
  • Without glass beads: Classic formulation (surface application of glass beads is ordered separately).

By climatic conditions:

  • ❄️ For northern regions: operation at low temperatures.
  • ⛅ For temperate climates: standard seasonal temperature changes.
  • ☀️ For hot regions: formulation designed for high summer temperatures.

TECHNICAL SPECIFICATIONS AND COLOURS

White (Luminance ≥ 80%)
Yellow (Luminance ≥ 50%)
Red, blue, green, black

Parameter Value / Indicator
Mass fraction of non-volatile matter 98 ± 1%
Curing time to Degree 3 (at +20 °C) not more than 20 minutes
Flowability 11–15 cm
Luminance factor (white colour) not less than 80%
Luminance factor (yellow colour) not less than 50%
Packaging Metal buckets of 20 kg and 30 kg

CONSUMPTION RATE AND APPLICATION TECHNOLOGY

Solid marking

5.0–7.5 kg/m²

Structural marking

3.5–5.0 kg/m²

Profile marking

7.0–12.0 kg/m²
(depends on profile height)

ℹ️

Conditions and composition: Apply to a dry, clean surface at an ambient temperature of at least +10 °C. Hardener (1–2% by weight) is introduced immediately prior to application. The composition contains no organic solvents.

FULL SET OF DOCUMENTATION

We promptly provide laboratory quality certificates, TR CU 014/2011 declaration, and technical data sheets (TDS).

📄 TR CU 014/2011
🧪 Quality certificate

NEED A CONSULTATION OR BATCH CALCULATION?

A manager will contact you within 10 minutes during business hours to clarify the details. The plant laboratory can adjust viscosity and cure time to meet the requirements of your technical specification.

📦 Packaging: metal buckets of 20 and 30 kg
🏭 Direct deliveries from the plant

Submit a request and our specialist will contact you shortly